Keypad lock in Bonneville Hills
Tom Hanks, owner, 24/7 Express Handyman Service · Updated September 2026
24/7 Express Handyman Service installs keypad locks in Bonneville Hills. 2-1/8 or 1-1/2 inch door holes and a 2-3/8 or 2-3/4 inch backset are what a Kwikset touchscreen deadbolt is made to fit. (Kwikset 275 Touchscreen Electronic Deadbolt Installation and User Guide) 1300 South and 2100 East form a commercial node, and the majority of that node is located in the Bonneville Hills neighborhood. (Bonneville Hills Neighborhood | Council District 6 (Salt Lake City)) In the Salt Lake City & Millcreek zone, scheduled work is $95/hour with a 2-hour minimum and no dispatch fee, plus a $15 fuel surcharge.
How much does a keypad lock job cost in Bonneville Hills?
From $205
Keypad lock in Bonneville Hills starts at $205: the 2-hour minimum at $95/hour ($190) plus the $15 fuel surcharge, with no dispatch fee. Time past 2 hours is billed in 30-minute steps. Larger parts are billed at cost plus 25%.
Call now
Salt Lake City & MillcreekAnswered 24/7 by Tom or his dispatcher.
Dispatch fee $199–$349 by time of day, due on arrival, covering the first hour on site. After that, $150/hour in 30-minute steps. Fuel surcharge $15. Supplies fee $50. Full price sheet and estimator
Typical arrival in the Salt Lake City & Millcreek zone: 60–90 minutes.
24/7 Express Handyman Service confirms the address, the zone rate and the dispatch fee, and takes a card, before rolling.
What 24/7 Express Handyman Service does on site
- Installs battery-powered keypad and smart deadbolts in existing door preps, or bores new holes to the lock maker's template.
- Adjusts the strike and latch so the bolt throws fully without the door being pushed or lifted.
- Sets up the master code with the owner and tests every code, the physical key and the battery backup before leaving.
How it works
- The owner picks the lock, and the door thickness, hole size and backset are measured to confirm it fits.
- The door prep, strike alignment and install are priced in writing.
- The lock is installed, the strike is adjusted, and the door is tested from inside and out.
- Referred out: hardwired access systems, doorbell wiring and any new electrical work.
What happens next
- The written scope and price come first; the owner sets or confirms the codes at the end of the visit.
- Photograph the damage before anything is moved and keep every receipt; 24/7 Express Handyman Service provides an itemised invoice your insurer may ask for. The dispatch fee and job cost are paid by you on the day.
In Bonneville Hills
Bonneville Hills is a predominantly single-family residential neighborhood closest to Foothill Village, a semi-regional shopping center, and its streetscapes resemble older East Bench neighborhoods, with uniform home setbacks and extensive street trees. (Bonneville Hills Neighborhood | Council District 6 (Salt Lake City)) The Bonneville Hills neighborhood consists of predominantly single-family homes built during the middle of the 20th century. (East Bench Master Plan (Salt Lake City Planning Division, 2017)) The Salt Lake City segment of the Wasatch fault generates large earthquakes of about magnitude 7 on average every 1,350 years, and the most recent was about 1,300 years ago. (Maps Show Potential Geologic Effects of a Magnitude 7 Earthquake | Utah Geological Survey) A brick building with rows of bricks turned endways every five to six rows may be unreinforced masonry, a pattern once used to add strength before steel reinforcing was required. (Unreinforced Masonry | Earthquakes (Utah Division of Emergency Management)) Utah updated its building codes in the 1970s to outlaw construction of new unreinforced masonry buildings, so URM buildings are typically older structures. (Unreinforced Masonry | Earthquakes (Utah Division of Emergency Management))
Calls come from around Foothill Village, Anderson-Foothill Library, 13th and 21st.
Every job 24/7 Express Handyman Service takes on is under $3,000 including labor, materials and any change orders (Utah Code §58-55-305); a change that would push a job over that line is referred to a licensed contractor, not written up as a second job. plumbing, electrical, HVAC, gas appliance / combustion system work is referred to a licensed trade.
Sources
- Kwikset 275 Touchscreen Electronic Deadbolt Installation and User Guide — retrieved 2026-09-23
- Bonneville Hills Neighborhood | Council District 6 (Salt Lake City) — retrieved 2026-09-23
- East Bench Master Plan (Salt Lake City Planning Division, 2017) — retrieved 2026-09-23
- Maps Show Potential Geologic Effects of a Magnitude 7 Earthquake | Utah Geological Survey — retrieved 2026-09-23
- Unreinforced Masonry | Earthquakes (Utah Division of Emergency Management) — retrieved 2026-09-23