Install a storm door in East Bench
Tom Hanks, owner, 24/7 Express Handyman Service · Updated September 2026
24/7 Express Handyman Service hangs storm doors in East Bench. 16 CFR 1201 names storm doors and combination doors among products with glazing safety rules. (eCFR 16 CFR Part 1201: Safety Standard for Architectural Glazing Materials) 77% of housing in Salt Lake City's East Bench community was owner-occupied as of the 2010 Census, compared with 49.7% citywide. (East Bench Master Plan (Salt Lake City Planning Division, 2017)) In the Salt Lake City & Millcreek zone, scheduled work is $95/hour with a 2-hour minimum and no dispatch fee, plus a $15 fuel surcharge.
How much does a storm door job cost in East Bench?
From $205
Storm door in East Bench starts at $205: the 2-hour minimum at $95/hour ($190) plus the $15 fuel surcharge, with no dispatch fee. Time past 2 hours is billed in 30-minute steps. Larger parts are billed at cost plus 25%.
Call now
Salt Lake City & MillcreekAnswered 24/7 by Tom or his dispatcher.
Dispatch fee $199–$349 by time of day, due on arrival, covering the first hour on site. After that, $150/hour in 30-minute steps. Fuel surcharge $15. Supplies fee $50. Full price sheet and estimator
Typical arrival in the Salt Lake City & Millcreek zone: 60–90 minutes.
24/7 Express Handyman Service confirms the address, the zone rate and the dispatch fee, and takes a card, before rolling.
What 24/7 Express Handyman Service does on site
- Opening measured and checked for square so the storm door kit fits the existing brick mould
- Z-bar frame, door, closer and latch installed per the manufacturer's instructions
- Sweep, closer tension and wind chain adjusted so the door seals and does not slam
How it works
- Measure the opening and confirm hinge side and handle clearance with the entry door hardware
- Fit and fasten the hinge-side rail, hang the door, and install the remaining frame rails
- Mount the closer, latch and sweep, then adjust for a smooth close and even seal
- Referred out: rotted door trim or framing beyond a small patch goes to a licensed general contractor
What happens next
- The written scope and price come first; the opening is measured before you buy the door.
- Photograph the damage before anything is moved and keep every receipt; 24/7 Express Handyman Service provides an itemised invoice your insurer may ask for. The dispatch fee and job cost are paid by you on the day.
In East Bench
Development in the East Bench neighborhood is relatively young and suburban, with larger lots and homes, curving streets and an abundance of cul-de-sacs, a pattern shaped by the steepness of its location on the slope of the foothills. (East Bench Master Plan (Salt Lake City Planning Division, 2017)) Approximately one-third of East Bench neighborhoods developed prior to World War II. (East Bench Master Plan (Salt Lake City Planning Division, 2017)) A scenario magnitude 7 earthquake is estimated to produce an average fault scarp height of 6.1 feet where faulting occurs along the East Bench, enough displacement to cause irreparable damage to any structure built across the scarp. (Maps Show Potential Geologic Effects of a Magnitude 7 Earthquake | Utah Geological Survey) In a scenario magnitude 7 earthquake, landsliding would likely be most severe on Wasatch Range mountain spurs, threatening downslope development such as the East Bench, although prehistoric landslide deposits on these slopes are relatively rare. (Maps Show Potential Geologic Effects of a Magnitude 7 Earthquake | Utah Geological Survey) Salt Lake City's wildland urban interface code adds fire safety rules for properties near undeveloped natural areas, covering building and roofing materials, how buildings are built, landscaping, and the space required between buildings and wildland. (SLC Wildland Urban Interface Fire Code | Salt Lake City Council Office)
Calls come from around Foothill Drive, Parley's Way, Bonneville Shoreline Trail.
Every job 24/7 Express Handyman Service takes on is under $3,000 including labor, materials and any change orders (Utah Code §58-55-305); a change that would push a job over that line is referred to a licensed contractor, not written up as a second job. plumbing, electrical, HVAC, gas appliance / combustion system work is referred to a licensed trade.
Sources
- eCFR 16 CFR Part 1201: Safety Standard for Architectural Glazing Materials — retrieved 2026-09-23
- East Bench Master Plan (Salt Lake City Planning Division, 2017) — retrieved 2026-09-23
- Maps Show Potential Geologic Effects of a Magnitude 7 Earthquake | Utah Geological Survey — retrieved 2026-09-23
- SLC Wildland Urban Interface Fire Code | Salt Lake City Council Office — retrieved 2026-09-23