Winter blowout in Sugar House

Tom Hanks, owner, 24/7 Express Handyman Service · Updated September 2026

24/7 Express Handyman Service blows out sprinkler lines in Sugar House. 80 psi is the most air pressure rigid PVC sprinkler pipe should see in a blowout, and 50 psi for flexible poly pipe. (Home Sprinkler Systems: Preparing Your Sprinkler System for Winter | Colorado State University Extension) 601 properties make up the Highland Park National Register historic district, which sits about half a mile southeast of the Sugar House Business District between Elizabeth Street, 1500 East, 2700 South and Parkway Avenue. (Sugar House Community Master Plan (Salt Lake City Planning)) In the Salt Lake City & Millcreek zone, scheduled work is $95/hour with a 2-hour minimum and no dispatch fee, plus a $15 fuel surcharge.

How much does a winter blowout job cost in Sugar House?

From $205

Winter blowout in Sugar House starts at $205: the 2-hour minimum at $95/hour ($190) plus the $15 fuel surcharge, with no dispatch fee. Time past 2 hours is billed in 30-minute steps. Larger parts are billed at cost plus 25%.

See the full price sheet and estimate your own job

Call now

Salt Lake City & Millcreek

(801) 999-0827Text photos

Answered 24/7 by Tom or his dispatcher.

Dispatch fee $199–$349 by time of day, due on arrival, covering the first hour on site. After that, $150/hour in 30-minute steps. Fuel surcharge $15. Supplies fee $50. Full price sheet and estimator

Typical arrival in the Salt Lake City & Millcreek zone: 6090 minutes.

24/7 Express Handyman Service confirms the address, the zone rate and the dispatch fee, and takes a card, before rolling.

Young maple coated in icicles after a lawn sprinkler ran during a freezing night
Photo: Famartin, CC BY-SA 4.0

What 24/7 Express Handyman Service does on site

How it works

  1. Confirm the shutoff location, the pipe type and that a blowout fitting exists downstream of the backflow preventer
  2. Set the compressor regulator below the pipe limit, then run each zone from the controller while the air pushes water out
  3. Drain drip filters, leave the controller off and write down anything that needs spring repair
  4. Referred out: backflow preventer testing or repair, and adding a missing blowout fitting at the drinking-water connection, go to a certified backflow tester or licensed plumber; controller wiring goes to a licensed electrician

What happens next

In Sugar House

Sugar House architecture is primarily residential, ranging from imposing Victorian residences and spacious homes near the Salt Lake Country Club to Craftsman bungalows and tracts of post-World War II cottages. (Sugar House Community Master Plan (Salt Lake City Planning)) From 1910 to 1926, developers Kimball and Richards annexed and built approximately 600 homes on 250 acres of vacant land south of Parley's Creek that they had purchased in 1909. (Sugar House Community Master Plan (Salt Lake City Planning)) Most of Emigration Creek through Sugar House is bounded by steep banks and runs through existing residential areas, and many residents have rear yards within close proximity of the streambed. (Sugar House Community Master Plan (Salt Lake City Planning)) Converting two-story older homes originally built as single-family dwellings into multi-family units is fairly common in Sugar House, and these conversions were often done illegally without a building permit or compliance with city zoning and code regulations. (Sugar House Community Master Plan (Salt Lake City Planning))

Calls come from around Sugar House Park, Sugar House Monument, Westminster University.

More about winter blowout

Every job 24/7 Express Handyman Service takes on is under $3,000 including labor, materials and any change orders (Utah Code §58-55-305); a change that would push a job over that line is referred to a licensed contractor, not written up as a second job. plumbing, electrical, HVAC, gas appliance / combustion system work is referred to a licensed trade.

Sources

All sources

Call (801) 999-0827Text

Answered 24/7 by Tom or his dispatcher.